How To Install
Installation of Infinity Faders is quick and easy. In most cases, all that is required is removal of the fader faceplate by removing all of its screws. Then, simply disconnect the old fader from it’s mounting position, snap in the Infinity Fader, and replace the faceplate. It really is that easy!
If you’re a musician who isn’t sure how to install the Infinity Fader on your equipment, contact us and we’ll reply with expert guidance and support.
For quick removal of stock faders, use the steps below:
Step 1: Remove the old fader knob.
Step 2: Remove the faceplate screws from the mixer (total of 6).
Step 3: Remove the two screws that secure the fader.
Step 4: Remove the wiring harness attached to the fader.
Step 5: Remove the fader from the mixer.
Step 6: Flip the fader upside down and remove the two assembly screws.
Step 7: Flip it back over and remove the black plastic rail guard.
Step 8: Remove the rubber bumper ring, also know as the o-ring, & slide the fader off.
*All should take less than 5 minutes